KingPo Technology Development Limited
IEC Testing Equipment
Add to Cart
IEC 60884-1 Figure 14 Non-Solid Pins Test Device For Mechanical Strength Test of Pins of Portable Accessories
Product overview:
The appliance is checked by the test of clause 24 and, for pins which are not solid, by the following test which is made after the test of clause 21. A force of 100 N is exerted on the pin, which is supported as shown in IEC60884-1, figure 14, for 1 min in a direction perpendicular to the axis of the pin, by means of a steel rod having a diameter of 4,8 mm, the axis of which is also perpendicular to the axis of the pin. During the application of the force, the reduction of the dimension of the pin at the point where the force is applied shall not exceed 0,15 mm. After removal of the rod, the dimensions of the pin shall not have changed by more than 0,06 mm in any direction.
Standard: IEC 60884-1 2013 clause 14.2 figure 14
Application: This device is use to test the mechanical strength of Pins of portable accessories.
Test sample: Non-solid pins
Feature: Apply a 100N force as per standard requirements with standard requirements.
Technical parameters:
1,Steel rod:Φ4.8mm；
2,Load weight:100N；
3,The stress pushed on bolt is from the rotating handwheel operated by manual.
| Steel rod | Φ4.8mm |
| Weight | 100N |
| Test standard | IEC 60884-1 2013 clause 14.2 figure 14 |
| Manual rotating the wheel so that the pin bearing pressure, time for 1min. | |
